Your Digital Media Has Never Looked So Good

 
riroadmap
Topic Author
Posts: 1
Joined: Mon Jan 04, 2010 6:00 pm
Location: Coventry, RI USA

SOUNDBRIDGE M1001 POWERS UP BUT WILL NOT WORK

Mon Jan 04, 2010 6:13 pm

I have a Soundbridge M1001 which was put away for a while during remodeling. It worked fine but upon installing it in my ham shack, it does not work.

Upon applying power...

The display displays ROKU and goes thru the usual boot up. After the text LET THE MUSIVC PLAY is displayed, the display goes out. However there is communications with the Hub but no audio or remote function.

What is the procedure to have this repaired if there is no device reset available

Thanks
Larry
Lawrence M Celani
 
amdb7
Posts: 95
Joined: Fri Nov 09, 2007 3:27 am

Tue Jan 05, 2010 7:10 am

After it says "Let the music play" and the display goes out, did you then press the Power button on your M1001's remote control?

The default on these is to go back to the state they were in when they were powered off. So if the last state was Standby, the device will return to Standby after it boots up. This means a dark display unless you have configured it differently.

Obviously check the batteries in your remote.

If this doesn't work, find the address of the M1001 (such as 192.168.1.4) from your router, and go to that address in your browser to see if you can access the M1001's interface.

If you can access the M1001 interface, go to Presets, and click Play on one of them to see if the M1001 lights up.

Who is online

Users browsing this forum: No registered users and 4 guests