Your Digital Media Has Never Looked So Good

 
cabin_fever
Topic Author
Posts: 1
Joined: Sun Jan 15, 2012 7:21 am

Roku C-8-DMX Send break and DMX signals

Sun Jan 15, 2012 7:24 am

Hello there,

i own a Roku C-8-DMX and i try hard to control it. I tried alot of stuff but it just won't work...

It only sends 0/255/0/255/0/255... DMX data on all channels all the time...

How can I configure the "break" signal in Bright Author?
How do I have to send it? Serial (no cr), Serial CR or Serial "," spread?
How do i send Signals? Is is like with this board ( http://www.hms-electronics.com/Roku/c_16_dmx.htm ) where i have to send Commands first?

I really need help. I somehow don't get it from your documentation on the website.

Thank ypou very much!
 
RokuLyndon

Re: Roku C-8-DMX Send break and DMX signals

Sat Jan 21, 2012 8:52 am

How can I configure the "break" signal in Bright Author?

I'm not sure what you mean by a break signal. Did you contact HMS?


How do I have to send it? Serial (no cr), Serial CR or Serial "," spread?
You would use the sendbytes feature to send the decimal values.

How do i send Signals? Is is like with this board ( http://www.hms-electronics.com/Roku/c_16_dmx.htm ) where i have to send Commands first?
There should be an exact diagram and directions for your board. But, most of the board coummunication worked in a similar fashion. You send decimal bytes to make changes on your dmx settings.

Who is online

Users browsing this forum: No registered users and 4 guests