Hi I'm trying to control a NEC U301 projector via the Serial or Lan connectors all I need to do is power on or off the projector. I have the HEX control codes but not sure what form to send them to send them via Bright Author. I'm using a HD1010.

These are the codes I need to send

Power ON
02H 00H 00H 00H 00H 02H

Power OFF
02H 01H 00H 00H 00H 03H

I have tried sending them as
&H2 &H1 &H0 &H0 &H0 &H3 and decimal numbers and with comas separating.

Any advice please
Mark

check out this faq:

http://support.brightsign.biz/entries/2 ... ightauthor

Thanks for the help,
I have now got it working as the tutorial said I had to convert to Decimal and send as a Serial - Send Byte.
But I had to send each part separately. Only 6 sets of numbers in my case so not a big problem.

I can now turn the projector on or off when I want it to.

Thanks again Mark