Telnet works, but only in Safe Mode, nothing else works (no web interface, SoundBridgeCommander does not connect).
Does anybody know how I can do a factory reset in telnet? Or how the "mediaupgrade" command could work? How can I get a file on the soundbridge? Is the "current" firmware still on it, maybe I can do a reset that way?
Version is 2.5.150
SoundBridge> ?
Valid commands are:
? - displays this list
help - provides help on a command
clear - clears the terminal window
stty - sets shell tty parameters
consoleprint - sets consoleprint on or off
version - prints out the software version
exit - exits the shell
cycles - displays a count of processor cycles
uptime - reports system uptime
reboot - reboots the system
ps - lists threads
ifconfig - lists network interface configurations
ping - pings an ip address
memstat - prints out memory statistics
clearsettings - clears CascadeSettings and reboots
ftpsettings - Send the current settings block via FTP
mediaupgrade - Upgrades the firmware from a file on the local storage.
mfg - performs mfg tests
irman - capture, monitor or send IR commands
Thanks in advance... help very much appreciated!