Your Digital Media Has Never Looked So Good

 
User avatar
destruk
Topic Author
Posts: 2510
Joined: Sat Dec 18, 2010 4:58 pm

SG Timeout on playing a video

Wed Nov 29, 2017 10:38 am

Hello, since Firmware 8.0 when my scenegraph app is told to play a video it is timing out after 30 seconds.  Does playing video need to be done in a task node now?  If I tell it to play a couple times after the initial timeout then it plays ok.  It is set up to pull from the LAN.  Firmware 7.7 didn't have this issue.  I also notice in the debugger it is throwing up a whole lot more warnings than it did before - did you guys turn on extreme debug log messages (like image size is larger than display resolution) ?
 
User avatar
destruk
Topic Author
Posts: 2510
Joined: Sat Dec 18, 2010 4:58 pm

Re: SG Timeout on playing a video

Wed Nov 29, 2017 10:41 am

Also, not to complicate the thread, but it still does the loud chirp/crackle/pop when unpausing, and it lags to a single frame pause (slowing down in nifty matrix mode first), and then the audio starts up again and it resumes skipping missed frames during playback.  Have you reduced the ethernet speed for local streaming to say, 30kbps instead of the 100 mbps ethernet?  Perhaps Roku shouldn't be the local streaming solution we've been using for years and we should just replace it with something else?
 
bojancv
Posts: 3
Joined: Wed Nov 22, 2017 2:42 am

Re: SG Timeout on playing a video

Mon Dec 04, 2017 9:01 am

Any info on the video timeout issue? 

Who is online

Users browsing this forum: No registered users and 6 guests