Hi, I've a problem with my SoundBridge unit.

I updated my SoundBridge M400PX to the current firmware, and now it get stuck in booting screen. How can I get it to work again?

Thanks

Have you tried to start it in Safe Mode?

I didn't know that there is a safe mode... How can I start it?

From the Roku website:

Try booting your SoundBridge in "Safe Mode" as follows: Unplug your SoundBridge from power. Next, disconnect the Ethernet cable and remove the wireless card. Point the SoundBridge remote control at the SoundBridge and press and hold any key on the remote (TIP: The arrow buttons are large and easy to hold down). Continue holding down the button and pointing the remote at the SoundBridge while you reconnect the SoundBridge to power. After a few seconds, the SoundBridge should boot with "Safe Mode" displayed on the screen. Choose "Reset to factory defaults" and follow the on-screen instructions to reset the SoundBridge.